Ada COSMO 150 Video Operating Manual page 14

COSMO 150
14
Offset - change the zero point
If you selected the Offset function in the menu, you can now adjust the value using buttons
or . Press the key for a long time to increase the rate of change of the values.
Tilt sensor Calibration
You can calibrate the tilt sensor by two measurements on a level surface (e.g. on the marble floor or
tabletop).
A. Press button to calibrate the tilt sensor.
B. Carry out a first measurement on a level surface. Press button
C. Rotate the device horizontally through 180°.
D. Press button to finish the second measurement.
Then the tilt sensor is calibrated.
VIDEO
to confirm the measurement.