Pioneer XDJ-R1 Service Manual page 26

1
6. Error history display mode
A
• When the TRACK SEARCH p or o button is pressed while the version of SYSTEM is displayed, the latest 16 errors
in history are shown.
• MEDIA name (USB/CD) where an error occurs is displayed in the upper row of the dot display and the error number is in the
lower row.
• The history can be reset by performing Factory Reset.
Error numbers to be memorized
Error No. Error name
E-7201 CANNOT READ DISC
E-8301 CANNOT READ DISC
B
E-8302 CANNOT PLAY TRACK
E-8303 CANNOT PLAY TRACK
E-8304 UNSUPPORTED FILE FORMAT
E-8305 UNSUPPORTED FILE FORMAT
E-9101 MECHANICAL TIME OUT
C
7. displaying A/D values mode
• When the unit is powered on while the TIME and HOT CUE B buttons of DECK 1 are pressed simultaneously, this mode
starts (STEP No. 0).
No. Step
0 Select the mode.
1 Start measuring.
D
2 Set the initial value.
3 measuring.
4 Check measurements.
5 Finish measuring.
E
The VR name that is indicated
F
26
1
2
Error details
TOC data cannot be read.
• Failed to search the address you are looking for.
• Cannot read the address.
• Cannot close the focus servo.
• Pickup does not return to the inner perimeter.
• Failed the search of the address you are looking for.
• Cannot read the address.
• FILE OPEN ERR.
Buffer under-run error.
MP3 DECODE ERROR.
UNSUPPORTED FILE.
Mechanical error in disc loading (Time out).
Start the mode of displaying A/D values.
Press the SYNC button, SYNC indicator lights up, and Start measuring.
About all VRs
Stores the average of 8 times value that was read at this time. This is the initial value.
About all VRs
Reading the value (absolute value) of the difference between the initial value stored in the "2",
and stores the largest.
Rotate "SELECTOR",
FL (CH1) display the name of VR (PITCH1_1) and the maximum value of VR "PITCH1_1" that stored in the "3".
FL (CH2) display the name of VR (PITCH2_1) and the maximum value of VR "PITCH2_1" that stored in the "3".
FL display is shown in the table below will change A, B, C......M, A, B,... By clockwise rotation.
By counterclockwise rotation, M,L,K,......A,M,...
Press the SYNC button, SYNC indicator lights off, and finish measuring.
Table. Which VR is displayed
Maximum value
XDJ-R1
2
3
Detail
CH1 FL CH2 FL
A PITCH1_1 PITCH2_1
B PITCH1_2 PITCH2_2
C DEPTH_1 DEPTH_2
D CH1_TRIM CH2_TRIM
E CH1_HI CH2_HI
F CH1_MID CH2_MID
G CH1_LOW CH2_LOW
H CH1_FILTER CH2_FILTER
I CH1_FADER CH2_FADER
J H.P.LEVEL AUX LEVEL
K H.P..MIXING MIC LEVEL
L CROSS FADER MIC EQ
M MASTER LEVEL BOOTH MONITOR
3
4
4