Pioneer XDJ-R1 Service Manual page 25

5
Commands of Test performance mode
This mode can precisely control servo's actions step by step.
Cautions for the usage of the Test performance mode because it could damage the CD drive if it is not used properly.
Servo All Off (INFO (UTILITY))
• When the INFO (UTILITY) button is pressed while servo is on, all the servo is off and [ALL OFF] is displayed
on the dot display area.
LD On/Off (TEMPO)
• When the TEMPO button is pressed, LD (Laser diode) is alternately turned on and off and [LD ON] or [LD OFF]
is displayed in the dot display area.
Focus On (BEAT FX (TRANS))
• When the BEAT FX (TRANS) button is pressed during PAUSE, LD is turned on and automatically focused and [FCS ON]
is displayed in the dot display area.
Spindle Kick, Tracking On/Off (BEAT FX (FLANGER))
• When the BEAT FX (FLANGER) button is pressed while tracking servo is off, spindle kick is performed, auto adjustment
and tracking servo are turned on and [TRK ON] is displayed in the dot display area.
• When the BEAT FX (FLANGER) button is pressed while tracking servo is on, tracking servo is turned off and [TRK OFF]
is displayed in the dot display area.
Tracking Off (BEAT FX (ECHO))
• When the BEAT FX (ECHO) button is pressed while tracking servo is on, tracking servo is turned off and [TRK OFF] is
displayed in the displayed in the dot display area.
Slide FWD (TRACK SEARCH p)
• When the TTRACK SEARCH p button is pressed while tracking servo is on, tracking servo is turned off and the slider is
moved approximately 2 mm in FWD direction and [SLD FWD] is displayed in the dot display area.
Slide REV (TRACK SEARCH o)
• When the TRACK SEARCH o button is pressed while tracking servo is on, tracking servo is turned off and the slider is
moved approximately 2 mm in REV direction and [SLD REV] is displayed.
Pickup UP/DOWN (BEAT FX (ROLL))
• When the BEAT FX (ROLL) button is pressed during STOP, LD is turned on, the pick-up is moved up and down with the
focus continued, and [PU UP/DN] is displayed in the dot display area.
Mode Change (MASTER TEMPO)
• When the MASTER TEMPO button is pressed in Test performance mode, MASTER TEMPO LED is turned off and
shifted to PLAYER performance mode.
* To start up the unit in Test mode in steps, input the commands in the following order: "Servo All Off," "Focus On,
" then "Spindle Kick, Tracking On."
5. Version checking mode
• When the MODE (HOT CUE/4-BEAT SAMPLER) button is pressed and held for approximately 10 seconds in the normal
usage conditions, this mode starts and the current version is displayed in the dot display area.
• When the CALL button is pressed, the following versions are toggled to be displayed.
(1) Ver. 1.00
↓
(2) DSP 1.00
↓
(3) SERVO 1.00
↓
(4) MIXER 1.00
↓
(5) CON 1.00
↓
(6) VFD 1.00
5
6
SYSTEM version
DSP version
SERVO version
MIXER version
UI version
VFD version
XDJ-R1
6
7
7
8
A
B
C
D
E
F
25
8