Setup Instructions - Toro MULTI-PRO 1100 Operator's Manual

IF INSTALLING OPERATOR ENCLOSURE AT
THIS TIME, DELETE STEPS 6-8, AND REFER
TO THE SET-UP INSTRUCTIONS PROVIDED
WITH THAT KIT FOR THESE ASSEMBLY
PROCEDURES.
IF MACHINE IS ALREADY EQUIPPED WITH A
HOSE REEL KIT, REMOVE AND DISCARD
EXISTING HOSE REEL MOUNT ANGLE
ASSEMBLIES.
AN ASSISTANT MAY BE NEEDED WHILE
INSTALLING THE ROPS PACKAGE ON THE
TORO MULTI-PRO™ 1100 AS OUTLINED IN THE
FOLLOWING STEPS.
Refer to illustrated parts list for the details of parts
used in assembling the ROPS.
NOTE: "RIGHT", "LEFT", "FRONT" AND "REAR"
ARE REFERENCED WHILE SEATED IN THE
OPERATORS POSITION.
1543
1. Open shipping carton, remove the shipping
clamps and rear ROPS bar. Mount the ROPS
bar to the vehicle frame by inserting (8) 1/2" x 1-
1/4" hex. hd. cap screws through the ROPS bar
and the vehicle frame. Start nuts on bolts by
hand. Use a torque wrench and torque nuts to
75 ft. lb. See FIG. 1.
4
SET-UP INSTRUCTIONS
1544
FIG. 1
1. Rear ROPS Bar
2. Loosely mount the left hand ROPS bar to the
rear ROPS bar by screwing (2) 3/8" x 1" hex hd.
cap screws with lockwashers, into the insert
anchors located in the top of rear ROPS bar.
1545
FIG. 2
1. R.H.-ROPS Bar
2. L.H.-ROPS Bar
3. Loosely mount the lower end of the hand
ROPS bar to the front vehicle frame using (2)
1/2" x 1-1/4" hex hd. cap screws, flatwashers, and
lock nuts. Start nuts on bolts by hand. See
FIG. 3.
2. Vehicle Frame
3. ROPS Cross Bar
4. Rear ROPS Bar