Toro MULTI-PRO 1100 Operator's Manual page 5

1546
FIG. 3
1. L.H.-ROPS Bar
4. Loosely mount the right hand ROPS bar to
the rear ROPS bar by screwing (2) 3/8" x 1" hex
hd. cap screws with lockwashers, into the insert
anchors located in the top of the rear ROPS bar.
5. Loosely mount the lower end of the right
ROPS bar to the right front vehicle frame using
(2) 1/2" x 1-1/4" hex hd. cap screws, flatwashers,
and lock nuts. Start nuts on bolts by hand. See
FIG. 3.
6. Loosely mount the ROPS cross bar to the
right and left hand ROPS bars by screwing (4)
3/8" x 1" hex. hd. cap screw with flatwashers and
lockwashers, into the insert anchors located in
the ROPS bars. See FIG. 2.
7. Align the ROPS bars and using a torque
wrench, tighten the mounting bolts to their proper
torque specifications as outlined in the TORQUE
SPECIFICATION CHART.
8. Mount the seat belt assembly to the rear ROPS
bar at a 45° angle using (2) 7/16" x 1-1/4" hex. hd.
cap screws, lockwashers, and hex nuts as shown
in FIG. 4. Using a torque wrench, torque nuts to
50 ft. lb.
NOTE: THE FOLLOWING STEP APPLIES ONLY
IF A HOSE REEL KIT IS TO BE INSTALLED ON
THE MULTI-PRO™ VEHICLE.
9. Mount the hose reel mounting plates to the
rear ROPS bar by screwing (4) 3/8" x 1" hex. hd.
cap screws with lockwashers attached, into the
insert anchors in the ROPS bar and tighten to 30
ft. lb. See FIG. 5.
SET-UP INSTRUCTIONS
2. Left Front Vehicle Frame
1547
FIG. 4
1. Seat Belt Assembly
1548
FIG. 5
1. Hose Reel Mounting Plate
TORQUE SPECIFICATION CHART
BOLT SIZE
3/8"
7/16"
1/2"
NOTE: TO ENSURE THE STRUCTURAL
RIGIDITY OF ROPS SYSTEM, MAINTAIN THE
TORQUE VALUES ON THE ATTACHING
HARDWARE AS OUTLINED ABOVE.
2. Rear ROPS Bar
2. Rear ROPS Bar
TORQUE VALUE
30 FT. LB.
50 FT. LB.
75 FT LB.
5