Gps Indicator Lights; Motor Unlock / Lock - Walkera Runner 250 PRO Quick Start Manual

8.2 GPS indicator lights

When the right red LED light (GPS) begin to flash, you can work GPS function.

8.3 Motor Unlock / Lock

Motor Unlock
After the success of IMU preheating, Check that all trims are neutral, the throttle stick is ALL the way Down
with the display indicating 0% throttle. Check that ALL switches are in the UP position.
Gently push the throttle stick down and move the rudder (YAW) stick to the left side and hold for more than
2 seconds. (on mode 2 radios throttle and rudder is the same stick).
You will see the left red LED light keeps on, indicating that motors are unlocked.
Be very careful at this point, as pushing the thottle up will start the motors.
You can test by pushing the stick up a little, the motors should start.
MODE 1 (Throttle stick on the right)
ELEV/Rudder stick
Motor Lock
Gently push the throttle stick down and move the rudder (YAW) stick to the right side and hold for more than
2 seconds. (on mode 2 radios throttle and rudder is the same stick)
You will see the left red LED light turns off, indicating that motors are locked.
TEST: Push the throttle stick up a little, the motors will not start when locked.
NOTICE: The motors are LOCKED by default after successful binding.
MODE 1 (Throttle stick on the right)
ELEV/Rudder stick
Quick Start Guide
Throttle stick
Throttle stick
-9-
MODE 2 (Throttle stick on the left)
ELEV stick
Throttle / Rudder stick
MODE 2 (Throttle stick on the left)
ELEV stick
Throttle / Rudder stick