Table of Contents
Advertisement
Mounting the Base Frame to Telescoping
Actuators
NOTE: Remove and discard any protective covering
that may be attached to the ends of the telescoping
acturatorss by removing the screws holding it in
place.
Locate 8–M6 x 35 screws and 8–M6 lockwashers
and 2–mounting plates.
Attach a mounting plate to each telescoping acturator
with 4–M6 x 35 screws and 4–M6 lockwashers as
shown in the inset drawing on Figure 16.
Locate 4–M12 x 50 screws and 4–M12 lockwashers.
Figure 16
Bottom Frame
Assembly
15mm
Make sure the flanges on the threaded inserts are up
as shown in Figure 16. Then mount the base assembly
onto the telescoping acturators with 4–M12
lockwashers.
Locate 4–M12 Leveling Studs and 4–M12 nuts.
Screw a M12 nut onto each leveling stud. Then screw
leveling studs into the inserts on each 45x60 profile at
the locations shown. Position each Leveling stud so
it is 15mm from the bottom of the profile, then tighten
the M12 (jam) nut.
Mount a 45 x 60 end cap at both ends of each 45x60
base profile.
M12x50
Screw
M12x50
Lockwasher
M12
Leveling
Stud
M12 Nut
Threaded Insert Flange
45x60
End Cap
M6x35
Screw
M6 Lockwasher
Mounting
Plate
Telescoping
Actuator
21
Advertisement
Table of Contents
