Table of Contents
Advertisement
20
Assembling the Base Frame
Locate
2–45mm
Bolt
Connector
Kits,
(P/N3842500921). Install one bolt connector into
one end of the remaining 45x45 profile, cross brace
as shown in Figure 14. Then push the square end of
45x45 Profile
(3842 990 644 1867)
an alignment pin into the center bore of the profile and
into the bolt connector to secure the connector into
place as shown.
Alignment
Install a bolt connector at the other end of the 45x45
Pin
profile and secure with an alignment pin.
Flat Side
Locate 4–M8 T-nuts and 4–M8 screws. Start each
M8 screw into the a M8 T-nut. Then insert each screw
assembly into the bolt connector slot on both ends of
Bolt
the 45x45 profile. Snap in cover caps to hold the
Connector
screws in place. Then insert the T-nuts into the slot on
Figure 14
the 45x60 profile as shown. Adjust the distance to
271 mm as shown, then tighten the bolt connector
assembly screws with a 8 mm allen wrench.
M8 Screw
M8 T-Nut
45x45
Profile
Cover
Cap
45x60
Profile
(898102148)
Figure 15
Advertisement
Table of Contents
