Table of Contents
Advertisement
18
Mounting Telescoping Actuator
Assemblies
Locate 8–adjustable gussets and break off the tabs
on the short side of all 8 gussets. Break off the tabs on
the long side of 4 of the gussets. On the remaining 4
gussets install 8 mm to 10 mm plastic adapters onto
the tabs on the long side of the gusset. These adapters
will be used at the outboard mounting locations as
indicated by the bold arrows in Figure 13.
Locate the 8–hex actuator mounting nuts that came
with the actuators and push them into the 8 small
pockets on the top of the gearboxes. Check to be sure
that holes in the nuts line up with the holes in the
housing.
Use 8–M8x16 Low Head Screws (P/N 2910 131
238) and attach the short side of the gussets to the
telescoping actuators. Be sure the gussets with plastic
adapters are mounted at the outboard locations as
indicated by the bold arrows in Figure 13. Make these
connections finger tight for now.
Locate 8–M8 T-nuts and 8–M8x16 Low Head Screws.
Insert the M8x16 screws into the long side of each
gusset and loosely attach a T-nut on the screws. Now
set the Telescoping Actuator assembly down onto the
table frame as shown in Figure 13, aligning the T-nuts
with the profile T-slots.
NOTE: It may be helpful to have an assistant
help hold and steady the Actuator assembly as
each T-nut is maneuvered under each adjustable
gusset.
Carefully center the actuator assembly on the table
frame and tighten all 16–M8x16 mounting screws.
Advertisement
Table of Contents
