Mounting Of The Table Securing Bracket; Projector Upward Projection Setting - NEC NP01TK Installation And Adjustment Manual

■ Mounting of the table securing bracket

Used to prevent the projector from falling down during table top projection. Use this for securing purposes and to prevent falls.
CAUTION
• Never fix the projector to a glass table or weak table. The table may be damaged as a result.
• Do not secure the projector at a narrow location such as the side board of the table as there is a risk that the projector may get detached.
1. Attach the table securing bracket.
(1) Turn the table clamp knob and loosen the screws to ensure there is suf-
ficient width for clamping.
(2) Use the enclosed M4 × 15 screws (6 units) to secure the table securing
bracket to the U-shaped bracket and slide arm.
Table securing bracket
Table clamp knob
2. Place the mounting unit for table
projection on top of the table and turn
the table clamp knob to secure it to the
table.
* Do not install the mounting unit for table projection on the outside from the
edge of the table.
(1) Slide the table clamp knob to the front and back to determine the clamp-
ing position and turn the table clamp knob to the right to secure it. When
securing to a table, you can achieve greater stability by securing the table
clamp knob as far in as possible.

■ Projector upward projection setting

When first shipped from the factory, the projector mounting adapter is set to project downwards (table top / floor). Change the direction if you are pro-
jecting downwards instead.
Preparations:
Disconnect the cables if there are any cables connected.
(1) Move the projector to the top until it stops.
(2) Plug in the driver into the driver hole for securing the pivot and remove the pivot securing screw. Use a magnetized Phillips screwdriver as the re-
moved screw may drop down.
(3) Rotate the projector 180 degrees in the direction of the arrow shown in the drawing until it stops. The projector cannot be set to project sideways.
(4) Attach and secure the pivot securing screw.
CAUTION
• The cables may be damaged if you rotate the projector with the cables still connected. Be sure to disconnect the cables first before turning the
projector.
Driver hole for securing the pivot
1
1
2
Pivot
securing
screws
3
ENG-6
2
Slide arm
Table clamp knob
4
U-shaped
bracket