Fujitsu M3097DE Cleaning And Maintenance page 38

Remove Pick roller 2 with the
6
same procedure of
Hold the new Pick roller 2 (see
7
the figure below) with your hand.
Pull up the hook of the sleeve on
the roller and slide the sleeve
toward the roller.
Pick roller 2
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Insert the bearing to the both
8
ends of the roller as shown in
right figure.
Then insert the sleeve side of
the rolle shaft into the lower hole
of the bracket at the center of
the ADF.
Next, slide the opposite end of
the roller into the lower bearing
at the far side of the ADF.
NOTE
When inserting the bearing, align the flat part of the
shaft with the flat part of the hole.
4-6
4
and 5 .
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
hook
slleve
269
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
(unit: mm)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○