Chapter 6: Operation; Keypad Controls - Raymarine RMK-10 Installation Instructions Manual

Chapter 6: Operation

6.1 Keypad controls

Connecting the keypad allows you to control your
multifunction display remotely.
1. Home — press to return to the Homescreen.
2. Menu — accesses menus. Press again to close
menus.
3. UniController — provides a rotary control and
a joystick that includes an OK push button for
using menus and applications.
4. Back — press to return to a previous menu or
dialog level.
5. - (Minus/Negative symbol) — press to range out.
6. + (Plus/Positive symbol) — press to range in.
7. Active — press to switch the active pane, or
to switch the active multifunction display (in
multiple display systems).
8. Waypoint / MOB — press and release to
access the waypoint options. Press again to
place a waypoint. Press and hold to place a
Man Overboard (MOB) marker at your current
position.
9. Standby (Auto) — press to disengage
integrated autopilot, press and hold to activate
Auto mode on integrated autopilot.
10. Power — see table below:
Configura- Display
tion State
1 Off / Standby * Power on
Multifunction
On
display
Multiple All displays
multifunction Off or in
displays Standby
All displays
On
1 Display
On and 1
display Off
or in Standby
Momentary Press and
press hold
—
Open Power off
Shortcuts / put into
page Standby
—
* Power on
all displays
Open Power down
Shortcuts all displays
page on
active display
Open Power down
Shortcuts active display
page on
active display
Note: * Only applicable to eS and gS Series
displays. a Series, c Series and e Series
displays cannot be powered on using the
keypad.
Note: In a multiple display configuration,
where displays are in different states, displays
that are turned off can only be turned on using
the Power button on the display.
11. Direction of Joystick Up.