Sanyo MDF-U333 Service Manual page 32

１０．Function mode １０．
１０． １０．
Functions are as follow.
F00 ： To return to PV display
F01 ： To change temperature of high temperature alarm
F02 ： To change temperature of low temperature alarm
F03 ： To change temperature of high temperature alarm
F04 ： To change temperature of low temperature alarm
F05 ： To set compressor delay start time
F06 ： To input service code (384)
F07 ： To adjust zero for temperature sensor
F08 ： To adjust zero for temperature sensor
F09 ： Not available
F10 ： Not available
F11 ： Not functioned. Return to PV display.
F12 ： To display temperature of temperature sensor (per 0.1℃)
F13 ： To display temperature of MDF-U537/U537D compressor protect sensor (per 1℃)
F14 ： To display temperature of temperature sensor (per 0.1℃)
F15 ： Not available
F16 ： Not functioned. Return to PV display.
F17 ： To set or check model code
model code
model code 002： MDF-U537
model code 003： MDF-U537D
F18 ： Preset value for second offset performance: -26℃ (for MDF-U537/U537D)
F19 ： Not functioned. Return to PV display.
F20 ： Not functioned. Return to PV display.
F21 ： To set communication ID（000～255）
F22 ： To set communication mode
F23,24,26～29 ： With input each function code, press SET key to sound buzzer 1 second
F25 ： To set alarm ring back time
Setting value: 000,010,020,030,040,050,060
Setting method ： ： ： ：
In PV display, keep
F00 ： Not functioned. In F00 displayed, press SET key to return PV display.
(Applied for lower compartment of MDF-U537D)
(Applied for lower compartment of MDF-U537D)
(Upper compartment sensor for MDF-U537D)
(Not available for MDF-U333)
(Solenoid valve control sensor for MDF-U537)
(Lower compartment sensor for MDF-U537D)
(Solenoid valve control sensor for MDF-U537)
(Lower compartment sensor for MDF-U537D)
001： MDF-U333
continuously to maintain input status.
key pressing over 5 seconds to enter function mode and will be
displayed "F00". Press
SET key again.
key to input required function code then press
− 29 −