Advertisement
If electrical bonding is required by the local governmental regulations, it shall be done in
accordance with Article No. 680 of the current National Electrical Code or the local
Code, whichever has jurisdiction. Five (#20) 1/4" x 1/2" Sheet Metal Screws and five
(#21) 1/4" x 3/4" Flat Washers are provided for this purpose. Secure one per slide leg
and one per ladder.
INSTALLED SLIDES' STRUCTURAL & INSTALLATION CHECKLIST
1) Inspect the runway for visible cracks or tears.
2) Inspect the slide for sharp edges, protrusions, cracks or tears.
3) Inspect all attachment flanges for loose or corroded fasteners.
4) Inspect all ladder tread or step-attachment points for evidence of shear, bending
yield, or fatigue in the ladder steps, rails, or attachments means. Yield is
evidenced by crystallization or fine cracking of the ladder tread and/or surface.
5) Inspect the ladder handrails for rigidity and attachment. (Can they be pulled out
of their sockets?)
6) Measure the following dimensions and compare with the Manufacturer's
Placement Instructions on pages 18 and 19. Also review the ANSI/NSPI-5 2003
STANDARD FOR RESIDENTIAL INGROUND SWIMMING POOLS.
• Measure the depth of water in front of the slide exit. (4-1/2' min. depth 4-
1/2' from exit end of slide.)
• Measure the height of the slide runway exit above the water. (20" max.)
• Measure the distance between the slide centerline and the edge of other
pool equipment.
7) Observe the position of the exit of the slide as shown in Figures 26, 27 and 28 on
pages 18 and 19.
PERSONALLY GIVE TO SLIDE OWNER THE ROGUE
OWNER'S MANUAL, THE WARRANTY CARD AND ANSWER ALL QUESTIONS.
ELECTRICAL BONDING
IMPORTANT
20
TM
TM
GRAND RAPIDS
Advertisement
