Meru Networks AP1014i Installation Manual page 14

1. From the controller, click Configuration > Devices > AP, and then select the AP.
2. Select one of these settings for the LED Mode setting:
Normal: LED is as described above
—
Blink: Sets the LED flashing; this is useful to locate an AP
—
Dark: Turns off the LED
—
3. Click OK.
The following table describes the colors that can be displayed by the AP1 014i Status LED and the details
corresponding to each color sequence.
Color
off
cyan
green blinking
green/white alternating
green/blue alternating
slow blue blinking
rapid blue blinking
red/yellow alternating
blue/yellow alternating
© 2012 Meru Networks, Inc.
State:
AP is off - either there is no power or the LEDs are set to Off on the
controller. Check the LED setting on the controller by clicking
Configuration > Devices > AP, selecting the AP and then checking the
setting for LED Mode.
AP is booting stage 1.
AP is booting stage 2.
AP is discovering the controller.
AP is downloading a configuration from the controller.
AP is online and enabled.
AP is online and enabled and there is activity on one or both radios.
Some AP failure occurred; check the controller for more details about
the alarm by clicking Monitor > Alarms > Pending Alarms.
AP is online and enabled and one or both radios are either scanning or
an admin has taken the radio(s) down.
AP1014i LED Codes
Installing AP1014i 5