Siemens SIMATIC IPC427E Operating Instructions Manual page 79

3. Remove the HDD/SSD from the enclo-
sure.
4. Loosen the HDD/SSD on the side from
the base plate as shown.
The HDD/SSD is retained on the base
plate by means of the studs shown. An
additional insulating film is inserted into
the base plate for HDD operation.
Installation
1. Place the HDD/SSD onto the base plate.
Observe the recess position shown when
installing an SDD. The SSD interfaces
should be located opposite the recess.
2. Insert the new HDD/SSD into the enclo-
sure.
Take care that the nameplate is on top.
Slide the HDD/SSD into the enclosure
until you can see the mounting holes.
SIMATIC IPC427E
Operating Instructions, 09/2017, A5E37454814-AB
Device maintenance and repair
7.3 Installing and removing hardware
79