Table of Contents
Advertisement
Indesit
Company
BASIC MACHINE USE
Note: Water Hardness MUST be set BEFORE first use or after module replacement.
Setting a Programme
1.
Turn the Machine On (On-Off Button). Start Pause Button Flashes.
2.
Push P button until required programme is displayed.
3.
Select any required Option.
4.
Press the Start Button (lamp will stop flashing and stay permanently on..).
Cancelling a Programme in progress
Press and Hold the ON/OFF BUTTON. All LED's will turn off.
End of Programme
END will be displayed.
SETTING THE WATER HARDNESS
These models have 5 Water Hardness Settings
depending on the water supply where the machine is
located.
The Water Hardness Setting must be set:
-
before the machine is used for the first time,
-
if a new Module has been fitted or if the machine
is moved to a different water area.
1
Start with the Machine "OFF"
2
Switch the Dishwasher "ON" using the ON/OFF Button
3
Wait a few Seconds. Switch the Machine "Off" using the ON/OFF Button.
4
Press and Hold the Start/Pause Button for a minimum of 3 seconds
5
Switch "ON" the Machine using the ON/OFF Button.
6
You are now in the Adjustment Menu, the current Hardness Level will be Displayed.
7
Select the Desired Hardness Level (1-5) by pressing the ECO Button, each press increases the
level by 1, the new setting will be Displayed.
8
Press the ON/Off Button immediately after setting the desired level, to Save the new Setting
NOTE: The Water hardness Level and Salt must still be used - even if multi-function tablets are
being used.
SETTING RINSE AID
If the User is not Completely satisfied with the Drying Results, the quantity of Rinse Aid dispensed can
be Adjusted.
- Switch on the Dishwasher using the On/Off Button, then wait a few seconds
- Turn Off using the On/Off Button
- Press the Start/Pause Button 3 Times
- Switch On the Dishwasher using the On/Off Button
- You are now in the Menu for setting the Rinse Aid. The current Rinse Aid setting will be displayed.
- Adjust the Level of Rinse Aid supply by pressing the ECO cycle Button. (range from 0 to Max). Each
press increase the level by 1. The new setting will be displayed.
- Press the ON/OFF Button to Save the Setting
Note: If the Rinse Aid Level is set to ZERO no rinse will be dispensed and the Low Rinse Aid "Warning"
will not illuminate when all the Rinse Aid is used up.
Service Manual UK
Water hardness setting table:
Display
Hardness
No.
(Clarke)
1
0 - 7
2
7.7 - 14
3
14.7 - 21
4
21.7 - 42
5
42 - 63
15 of 39
Notes
Salt not needed
Add Salt
Add Salt
Add Salt
Add Salt
English
Hide quick links:
Advertisement
Table of Contents
