Basic Machine Use - Hotpoint LTF11M121OUK Service Information

Indesit Company

BASIC MACHINE USE

Setting a Programme
1. Open the door and turn the machine On.
2. Press the P button, after each press, the display number will cycle to the next programme
number, until the desired Programme is shown.
3. Close the door, The machine will Start after about 10 seconds.
Cancelling a Programme in progress
1. Press and Hold the On/Off button until the machine beeps and the lamps all go out.
The programme is now cancelled.
End of Cycle
The Programme number will flash in the display when the final drying part of the programme is
completed.
Note: If the machine is silent and when the door is opened and the Programme Number is
permanently displayed, the cycle has not finished. Close the door and allow the programme
to continue. During the final part of the Drying Cycle the machine is paused.
On/Off Lamp Flashing
If the ON-OFF Lamp is flashing as well as a programme number the machine has a fault, see
Fault Codes and Diagnostics.
Adjusting the height of the upper rack
In order to make it easier to arrange the crockery, the upper rack may be moved to a higher or lower
position.
The height of the upper rack should be adjusted WHEN THE RACK IS EMPTY.
NEVER raise or lower the rack on one side only.
If the rack is equipped with a Lift-Up device* (see figure), lift it up by holding its sides. To restore the
lower position, press the levers (A) at the sides of the rack and follow the rack down.
Service Manual UK
10 of 40
English