Table of Contents
Advertisement
Indesit
Company
Low Salt Warning
An Optical Sensor is fitted to the salt container where the presence of salt breaks the beam in the sensor.
When the level of salt is below the sensor level, the receiving sensor receives the light beam from the
sending LED. The Low Salt warning lamp is switched on 6 washes after the sensor signals the module.
The sensor position is not at the bottom of the salt container because of possible false readings caused
by impurities that collect in the bottom of the salt container.
Low Rinse Aid
A float is fitted into the rinse aid dispenser and when the level of the float is near the bottom of the rinse
aid reservoir the float will trigger a signal to the Control Module to turn on the Low Rinse Aid Warning Lamp
Air Break Assembly
Located on the right hand side of the machine.
The Air Break Assembly carries out 3 functions:
1.
Stops filling water siphoning back into the mains
water supply.
2.
Vents the Steam from the dishwasher tub.
3.
Diverts 3% of the hard water fill into the tub to
avoid the water being too soft which could cause
excessive foam.
The Air Break also holds the regeneration valve
and the Water fill turbine.
Drying
The Natural Drying System uses Residual Heat and Rinse Aid to Dry the loaded dishwasher.
During the Drying Phase of the cycle the Water reaches a very high Temperature 70 ° C,.
Drying is carried out in 2 steps both with the machine paused (Circulating wash pump off)
1. Hot water in the tub
2. Hot water drained from the tub
Filtering System
The flat filter is made of metal and larger than previous models which will prevent the filter from clogging.
Flat Filter
Service Manual UK
Regeneration Valve
Bowl Filter
22 of 39
Fill Turbine
Micro Filter
English
Hide quick links:
Advertisement
Table of Contents
