Table of Contents
Advertisement
Indesit
Company
P. Display Board
1.
Remove outer door panel C).
2.
Remove console panel (6 screws) and disconnect wiring plugs (2). Note the connector orientation and
position. Carefully ease the ribbon cable (connected to the touch control surface) from its socket.
The touch control surface is an integral part of the console moulding and is not available separately.
3.
Remove the door switch (2 screws).
4.
Unclip the handle housing. Ensure correct position of the outer lip during reassembly. See Fig. 3.
5.
Using a flat bladed screw driver, carefully ease 8 clips securing display card cradle to console panel
(see Fig. 2 below), and remove the board assembly.
Fig.1
Console panel
Display / Control Board assembly
Fig.3
Handle Housing
viewed from user side
correct lip location
Service Manual UK
screw
Release clips (8)
Door Switch
screw
Handle Housing
30 of 39
Ribbon Cable
Front edge
Rear edge
English
Hide quick links:
Advertisement
Table of Contents
