Table of Contents
Advertisement
Indesit
Company
PROGRAMMING (Using Smartcard Reader / Card).
Smart
Card
Reader
If the Main Module has been replaced during a repair the module will require programming using the
following method.
1.
Do NOT connect the machine to electrical supply.
2.
Insert the pre-programmed card into the Card reader.
Care must be taken at this point to ensure the card is
inserted correctly with the Chip on the card facing the
PCB of the Reader.
3.
Insert the Reader & Card into module connection port
- see photo. You MUST hold the Reader in place
whilst programming is taking place.
4.
Connect the machine to the Electrical
LED's on the Smart Card Reader will light in this
sequence:
a)
Red OFF: Good Communication between Smart Card
Reader & Card.
b)
Red OFF; Green Blinking: Download taking place.
c)
At end, Green ON ---> Download OK.
d)
At end, Red ON ---> Download NOT OK.
5.
Programming Complete, disconnect the machine from
Electrical supply.
6.
Remove the Smart Card Reader.
Service Manual UK
supply, the
You MUST hold the Reader in place whilst
It does not stay in position on its own.
34 of 39
Smart Card
this card holds
the program file
and can ONLY
be used ONCE.
After the module
has been programmed
the card is automatically
erased.
Smart Card Reader
and Smart Card in use
programming is taking place.
English
Hide quick links:
Advertisement
Table of Contents
