Intermediate Calibration - Raymarine ST60 Tridata Owner's Handbook Manual

34

4.3 Intermediate calibration

Intermediate calibration enables you to:
•
•
•
To start Intermediate calibration, hold down the
for approximately 4 seconds (see Intermediate calibration flow chart).
To set the instrument status:
1. Press the
2. Press the
Note: You must not allocate more than one master depth instrument in
any system.
3. Press the trip and reset keys simultaneously again, to leave the adjust
Check the instrument software version.
Check the instrument status - either YES (master)) or NO (repeater).
You can also change the depth status, as required. This feature is par-
ticularly useful in preventing interference when using another prod-
uct (e.g. a fishfinder) that operates at 200 kHz.
Carry out a calibration run over a measured distance to ensure accu-
rate speed readings.
depth key to select the Instrument status screen.
trip and reset
mode, then press either
either YES (for master operation) or NO (for repeater operation).
mode.
ST60 Tridata Instrument Owner's Manual
keys simultaneously to enter the depth adjust
trip or reset to set the required status, i.e.
and keys
depth speed