Mounting The Sounder Module - Raymarine DSM30 Installation Manual

Chapter 1: DSM Installation
• Interference: The selected location should be far enough away from
devices that may cause interference, such as motors, generators, and radio
transmitter/receivers. (See the EMC guidelines earlier in this chapter.)
• Magnetic compass: Mount the unit at least 3 ft (1 m) away from a magnetic
compass.
• Cable runs: The unit must be located near a DC power source. The power
cable supplied is 10 ft (3 m).
• Environment: Provide good ventilation to prevent overheating.
CAUTION: Do Not Remove the Transducer Cable
Removing the transducer cable from the sounder module while
power is turned on can cause sparks. As with any electronic
device, be sure the sounder module is mounted where it is well
ventilated and free from gasoline fumes.

1.4 Mounting the Sounder Module

The DSM can be mounted either above or below deck using the supplied
hardware. To allow for ease of cable connection, mount the sounder module so
that the cables hang below the unit.
9.96 in (252.9 mm)
9.51 in (241.6 mm)
10.76 in (273.3 mm)
Weight: 2.2 lbs (1.0 Kg)
Compass Safe Distance: 39 in (1 m)
7.37 in (187.2 mm)
11
D7468-1