Removal - Jeep 2002 WJ Service Manual

21a - 98 TRANSMISSION AND TRANSFER CASE
OIL PUMP (Continued)
(3) Lubricate pump gears and place in the pump
housing. Insert pump gear (1) (Fig. 143) so that the
chamfer (arrow) points towards the pump housing.
Fig. 143 Oil Pump Gears
1 - OUTER PUMP ROTOR
2 - INNER PUMP ROTOR
1 - SHIFT MECHANISM
2 - SHIFTER BTSI LEVER
3 - ADJUSTMENT CLIP
PARK LOCK CABLE

REMOVAL

(1) Place the shifter in the PARK position.
(2) Lower the steering column cover.
(3) With the ignition switch in the "RUN" position
depress the park lock cable locking tab, located on
top of the cable connector at the steering column and
pull the park lock cable straight out.
(4) Remove the park lock cable from steering col-
umn (Fig. 144).
(5) Remove the floor console and related trim.
(Refer to 23 - BODY/INTERIOR/FLOOR CONSOLE -
REMOVAL)
(6) Disconnect the park lock cable from the shift
BTSI lever and remove the cable from the shifter
assembly bracket.
(7) Release the park lock cable from any remaining
clips.
(8) Remove park lock cable from the vehicle.
Fig. 144 Ignition Interlock Cable
4 - STEERING COLUMN ASSEMBLY
5 - INTERLOCK CABLE
WG