Transfer Case - Nv247 - Jeep 2002 WJ Service Manual

WG
TRANSFER CASE - NV247 (Continued)
(5) Install the rear driveshaft. Torque the bolts to
32 N·m (24 ft. lbs.). Be certain to install the drive-
shaft in the same position as before removal.
Fig. 247 Front Driveshaft Retaining Bolts
1 - TRANSFER CASE
2 - FRONT DRIVESHAFT RETAINING BOLTS
3 - REFERENCE MARK
SPECIFICATIONS

TRANSFER CASE - NV247

DESCRIPTION
Bolt, crossmember
Plug, Detent
Plugs, drain/fill
Bolts, case half
Nut, companion flange
Lock-nut, shift
Nuts, T-case mount stud
TRANSMISSION AND TRANSFER CASE
(6) Install the front driveshaft. Torque the bolts to
32 N·m (24 ft. lbs.) (Fig. 247). Be certain to install
the driveshaft in the same position as before
removal.
(7) Install the (2) lower fan shroud retaining bolts.
Torque the bolts to 15 N·m (132 in. lbs.).
(8) Lower the vehicle on the hoist.
(9) Install the (2) upper fan shroud retaining bolts.
Torque the bolts to 15 N·m (132 in. lbs.).
(10) Fill the transmission fluid to specification.
(11) Connect the negative battery cable.
TORQUE SPECIFICATIONS
N·m
41-47
16-24
41-54
27-34
122-176
27-34
33-41
Ft. Lbs.
30.2-34.7
11.8-17.7
30.2-39.8
19.9-25
90-130
19.9-25
24.3-30.2
21a - 137
In. Lbs.
-
-
-
-
-
-
-