Hyperterminal; Limits; Pin Connections; Data Output Example - norbar 43228 Operator's Manual

Hyperterminal

The standard HyperTerminal
output data. For more information see www.norbar.com and select FAQ.
TIP: Downloading of data can be speeded up by changing the LINE DELAY to 0 SECONDS.
TIP: To regulate the CONTINUOUS OUTPUT, set LINE DELAY to required time period.

Limits

The serial port will output LO / OK / HI when the limits are being used.
Some software, including the Norbar 'Torque Wrench Calibration Software' (Part 37705.XXX), will not accept
LO / OK / HI characters.
To remove LO / OK / HI set OUTPUT LIMITS to 'NO'.
The following table gives all options for the FIRST CHARACTER & OUTPUT LIMITS settings:
First
Character
-
+/-
NONE

Pin Connections

Data Output Example

Code: DP=Decimal Point.
TTT with the serial port set to the factory defaults. Reading 1068.4 lbf∙ft (clockwise).
1 0 6 8

Connector Type

9 way male 'D' type connector.
Connecting Lead
A 9 way female to 9 way female null modem connecting lead is included with the TTT for connection to a PC
with a 9 way male connector.
TIP: If PC to be used has a 25 way 'D' connector, use the Serial Data Lead Kit (part no 60248).
 program found in Microsoft
Example with No Limits or
Direction
Clockwise
Anti Clockwise
Clockwise
Anti Clockwise
Clockwise
Anti Clockwise
Pin No Function
1 Not Connected.
2 Received data (to TTT).
3 Transmitted data (from TTT).
4 Not Connected.
5 Signal ground 0V.
6 Not Connected.
7 Not Connected.
8 CTS (clear to send).
9 Not Connected.
CR=Carriage Return.
DP 4 SP
® Windows allows the user to view and store serial
OUTPUT LIMITS = NO
1.0335 N∙m
-1.0335 N∙m
+1.0335 N∙m
-1.0335 N∙m
1.0335 N∙m
1.0335 N∙m
SP=Space.
l b f DP
Example with
OUTPUT LIMITS = YES
LO 1.0335 N∙m
LO -1.0335 N∙m
LO +1.0335 N∙m
LO -1.0335 N∙m
LO 1.0335 N∙m
LO 1.0335 N∙m
f t CR
21