Table of Contents
Advertisement
Antenna Setup
Patriot Single Axis Inclined Orbit Tracking Wiring Procedure
The RC1500B's wiring is provided by a single actuator cable which consists of two
16-gauge wires for motor voltage and three shielded 22-gauge wires for the position
sensor.
1. The first step in wiring the back of the RC1500 is to cut back the outer jacket 9
¼ inches and remove the plastic film exposing the two sub-cables.
2. The removal of the outer jackets will reveal two 16 gauge wires (red and black in
color) and 3 triple shielded wires for the position sensor enclosed in a foil shield
with a bare drain wire.
Figure 5 – Stripped Outer Jacket
7
RC1500B Quick Start Guide
Advertisement
Table of Contents
