Removing and Replacing AC and DC Power Subsystem Components
Removing and Replacing an AC PEM
Cisco 12010, Cisco 12410, and Cisco 12810 Router Installation and Configuration Guide
7-32
This section contains the procedure to remove and replace an AC PEM from the
chassis.
Figure 7-15
identifies the components of an AC PEM.
Figure 7-15 AC PEM Components
1
Status indicators
2
Handle
Chapter 7
3
Ejector lever
4
Power ON/OFF switch (shown in the ON/1
position)
Maintaining the Router
OL-11496-01