AT&T TL96273 User Manual page 60

Multiple handset
Push-to-talk (PTT)
2. To end the PTT call, press
to talk Ended for a few seconds.
-OR-
Place the handset in the telephone base or charger to end the PTT call.
NOTE: After PUSH TO TALK is released, the PTT call remains open for a short time. If no
one presses PUSH TO TALK within 10 seconds, the PTT call ends automatically.
Using the telephone base:
1. To begin a PTT call to a single device:
• Press PTT when the telephone base is not in use. Use the dialing keys to
enter a handset number (1-9 for handsets 1-9, TONE
10, TONE
handset 12) to create the push-to-talk session.
-OR-
• Press PTT when the telephone base is not in use. Then press CID
DIR to scroll to the desired handset. Press
push-to-talk session.
2. The telephone base displays Connecting to HANDSET X... for a few seconds.
When the connection is made, both screens display Press and hold [PTT] to
talk and beep once.
3. Press and hold PTT on the telephone base. A chirp indicates your
microphone is on. Speak towards the MIC. Your voice is broadcast to the
destination handset. While you are speaking, the telephone base displays
PTT To HANDSET X (X represents the destination handset number).
4. Release PUSH TO TALK after speaking. The telephone base and the
destination handset beep once again. After the handset beeps, you can press
and hold PUSH TO TALK to continue speaking or the destination handset
can respond (see Answer a PTT call on page 57).
5. To end the PTT call, press CANCEL or
Push to talk Ended for a few seconds.
NOTE: After PTT is released, the PTT call remains open for a short time. If no one presses
PTT within 10 seconds, the PTT call ends automatically.
OFF/
and 1 for handset 11, or TONE
or END
CANCEL
and 2 for
SELECT
END . The telephone base displays
54
. The handset displays Push
and 0 for handset
or PTT to create the
or