Fujitsu AUU7RLF Design & Technical Manual page 49

5. Connect the cable to the terminals on the front case. Fix the cable together with the sheath
by using the cable tie. Cut off the excess cable tie.
Terminal screw
1. 12 V (Red)
2. Signal (White)
3. COM (Black)
CAUTION
!
• Be careful to avoid breaking the cable by over-tightening the binder.
• When connecting the remote controller cables, do not over-tighten the screws.
6. Attach the front case.
• Adjust the upper part of the front case first, then insert the front case until it clicks.
• When inserting the front case, do not pinch the cable.
CAUTION
!
Insert the front case firmly. If improperly attached, it will cause the front case to fall off.
Tightening torque
Remote controller
cable (sheath)
Good
Front case
Good Prohibited Prohibited
- 43 -
7 to 10 lbf • in (0.8 to 1.2N • m)
Cable tie
Hole for binder
2 mm
(1/16 in)
Prohibited
Click!
Prohibited
Prohibited