Table of Contents
Advertisement
holes for the control horn using a felt marker.
J. Attaching the control horn using two 2mm screws and backing
plate. It might be wisely to connect the pushrod at the z bent end and
insert the pushrod to the tube before installing the control horn.
Attach the rudder control horn in the same manner.
Note: The longer pushrod is for elevator, the short one is for rudder.
VI. Landing Gear Installation
A.
Landing gear is assembled with 4 wheel collars, 2 bushing, and 2
wheels. Install one wheel collar on to the landing gear, then slide the
brass bushing on, slide the wheel over the bushing, and finally install
the second wheel collar. Repeat process for other wheel.
B.
Using a hobby knife remove the covering over the landing gear
slot. Push the landing gear down into the slot. Apply a few of drops
of medium CA into the slot and slide the former into place. WARNING:
WHEN YOU INSERT THE FORMER, IT WILL SQUIRT EXCESS CA OUT
THE HOLES NEAR THE LANDING GEAR, SO BE CAREFUL!!
VII. Servo, Radio, Battery, & Switch Installation
A.
Using a hobby knife remove the covering film from the switch cut
out on the left side of the fuselage.
B.
Glue the two plywood pieces as the servo tray if you use the mini
servo. You might place your mini servo as a guide then glue the ply-
7
LANDING GEAR
Advertisement
Table of Contents
