Table of Contents
Advertisement
B.
Secure the motor tightly with enclosed Zip-Tie.
IV. Wing Hold Down Dowel Installation
A.
Cut away the covering film from the predrilled holes in the fuse-
lage with a hobby knife.
B.
Install dowels and place a drop of medium CA to hold dowels in
place.
V. Stab and Rudder Installation
A.
Center the main wing on the fuselage and attach using the rubber
bands provided.
B.
Determine the top and bottom of the stab like this: the sealed
edge of the elevator should be on top, and the beveled edge be on the
bottom.
C.
Place the stab on the tail of the plane and measure from points
shown above. This will square the stab in the saddle. Pin the stab in
5
STABILIZER
Advertisement
Table of Contents
