Configure Otv With Bdi Configuration On The Border Switches In - Cisco Nexus 7000 Series Configuration Manual

VXLAN BGP EVPN and OTV Interoperation
• The unique, primary gateway IP address (198.51.100.20 for vPC peer 1, and 198.51.100.30 for vPC
Step 6 The configurations are for DC-1. Similarly, configure for DC-2 too.
Configure OTV with BDI Configuration on the Border Switches in DC-4
These configurations are relevant to the OTV+BDI single box solution (comprising the vPC switch pair
Note
at the border, OTV1 and OTV2) and not to the legacy datacenter, where the two box solution comprises
of a separate OTV and aggregation switch.
OTV1 and OTV2 configurations:
Step 1 Configure OTV on OTV1
OTV1(config)# feature otv
The feature nv overlay command is a required command for this feature.
OTV1(config)# no otv site-vlan 111
• The otv site-vni command enables the OTV site specific VNI. This VNI should not be extended over
no ip redirects
ip address 198.51.100.30/24
ip address 198.51.100.1/24 secondary anycast-primary
ipv6 address 2001:DB8:1::1/64
no ipv6 redirects
fabric forwarding mode anycast-gateway
peer 2 switches) will be used for sending ARP requests over OTV. The common, secondary anycast
gateway IP address (198.51.100.1) will be used for sending ARP requests on the VXLAN side.
feature nv overlay
feature-set fabric
feature fabric forwarding
feature vni
vni 40000
system bridge-domain 2500-3500
bridge-domain 3500
member vni 40000
exit
encapsulation profile vni vsi_cisco
dot1q 60 vni 40000
exit
interface Ethernet 1/12
no shutdown
service instance 1 vni
encapsulation profile vsi_cisco default
no shutdown
otv site-vni 40000
interface Overlay1
otv join-interface Ethernet2/3
otv extend-vni 10000, 20000, 30000
otv vni mapping 10000, 20000, 30000 to vlan 1000, 2001, 3000
otv use-adjacency-server 10.0.0.1 192.0.2.1 unicast-only
no otv suppress-arp-nd
otv adjacency-server unicast-only
no shutdown
exit
otv site-identifier 0000.0000.000A
otv encapsulation-format ip gre
any overlay interface and should be operationally up before it can be configured as the OTV site VNI.
Configure OTV with BDI Configuration on the Border Switches in DC-4
Cisco Nexus 7000 Series NX-OS VXLAN Configuration Guide
123