Warm Tech CAC20KW Instructions Manual page 27

【 Assembling wheels and tube frame 】
1、insert the wheel axle to the corresponding hole of lower tube frame，set bushing G at the two ends，
slide the wheel F over the wheel axle H，put on wheel cap E。
2、Put the heater body on the lower tube frame B, make sure the 4 holes of handle frame point towards
the corresponding 4 holes on the lower tube frame respectively.
3、Insert screws J in the holes，place flat washers D under the lower frame B and tighten the
hexangular screw C。
4、Insert other screws in the holes respectively and use a screw driver to tighten them by the same way.
【 Dimensions 】
【Technical parameters】
27