Technical Specifications - Black & Decker BDL170 Instruction Manual

90506680 BDL170 laser 8/16/06
Decker location nearest you. To find your
local service location, refer to the yellow
page directory under "Tools—Electric" or
call: 1-800-544-6986 or visit
www.blackanddecker.com
Full Two-Year Home Use
Warranty
Black & Decker (U.S.) Inc. warrants this
product for two years against any defects
in material or workmanship. The defective
product will be replaced or repaired at no
charge in either of two ways.
The first, which will result in exchanges
only, is to return the product to the retailer
from whom it was purchased (provided
that the store is a participating retailer).
Returns should be made within the time
period of the retailer's policy for
exchanges (usually 30 to 90 days after
the sale). Proof of purchase may be
required. Please check with the retailer
for their specific return policy regarding
returns that are beyond the time set for
exchanges.
T T
T T
Problem
• Laser does not project
on wall.
• Laser projects on wall
but lines are not level.

TECHNICAL SPECIFICATIONS

Laser Diode Wavelength:
Laser Class:
Working Range:
Leveling Accuracy:
Auto Leveling Range:
Auto Leveling Lines Settling Time: <5 sec
Batteries:
Voltage:
Operating Temperature:
Imported by
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
7:20 AM Page 7
The second option is to take or send the
product (prepaid) to a Black & Decker
owned or authorized Service Center for
repair or replacement at our option. Proof
of purchase may be required. Black &
Decker owned and authorized Service
Centers are listed under "Tools-Electric" in
the yellow pages of the phone directory
and on our website
www.blackanddecker.com.
This warranty does not apply to
accessories. This warranty gives you
specific legal rights and you may have
other rights which vary from state to state.
Should you have any questions, contact
the manager of your nearest Black &
Decker Service Center. This product is not
intended for commercial use.
FREE WARNING LABEL
REPLACEMENT: If your warning labels
become illegible or are missing, call
1-800-544-6986 for a free replacement.
R R O O U U B B L L E E S S H H O O O O
R R O O U U B B L L E E S S H H O O O O
Possible Cause
• Weak batteries.
• The self leveling range
of the unit is +/-5
degrees, if the unit is not
held within 5 degrees of
vertical, the laser lines
will not project on wall.
• Wall on which the unit
is mounted or held must
be within +/- 5 degrees
of vertical for the self
leveling mechanism to
function correctly. If this
is exceeded, the lines
will still project but may
not be level.
• The laser on/off switch
must be pushed to the
full on position.
635 ± 5 nm (red color)
Class 2
Up to 20 feet (609 cm) (depends on light conditions)
±1/8 inch (3 mm) @ 10 feet (3 m)
±5°
2 AAA batteries (included)
3.0 Volt
41°F (5°C) - 104° F (40°C)
7
T T I I N N G G
T T I I N N G G
Solution
• Replace with fresh batteries.
• Be sure that the unit is as
straight up and down as
possible.
• Use the unit against vertical
walls only, lines will not be level
on sloped walls or other non-
vertical surfaces.
• Be sure laser on/off switch is
in the full on position.
See 'Tools-Electric'
– Yellow Pages –
for Service & Sales