Security Tronix ST-HDoC User Manual page 20

 Press the key
 Press the key
 Press the key
 Press the key
1) Set and go PS
Set PS:
A. Use the PTZ controls to move the camera to the desired position.
B. Press the key
yellow cursor to "Set PS", Press the key
Then Press the
Go PS:
Call the preset position. (1~128) The PTZ camera will go to the desired preset position.
In "PTZ Controller", Press the
key, to move the yellow cursor to "GO PS". Press the
Then press the key to call the preset position.
The camera moves to the preset position immediately, Lens zoom, focus and iris is will automatically
change to the preset parameters provided the camera is equipped with these features.
Tips：Preset position setting is saved in the PTZ camera's built in memory.
2) Menu of dome
The PTZ camera manufacturers may have different procedures for accessing the PTZ camera menu.
Please refer to the camera manual for specific instructions to access the PTZ menu. For example if the
camera menu is accessed by CALLING PRESET 64, use the steps below.
a. Press the key to enter PTZ controller submenu
b. Press the key , select preset position 64
key to enter the main menu of the PTZ camera's OSD.
c. Press the
ST-HDoC / ST-HDoC-MM
to control the PTZ direction of rotation
or to switch on or turn off the aperture.
or , adjust the focus manually
or , manually adjust the zoom
to enter the PTZ controller submenu. Press the key
key to save the preset position.
key to enter the PTZ controller submenu. Press the
to select the desired preset position number.
key to select the desired preset number.
16
to move the