Remote Interface Overview - HP E4418B User Manual

Power Meter Operation
Configuring the Remote Interface
11. Press
RTS/CTS
the following from the pop up menu:
OFF - Sets the RTS signal line permanently low.
ON - Sets the RTS signal line permanently high.
IBFull - Sets the RTS signal line high while the receiver buffer
can accept more data and sets RTS low when the data buffer is
full. The transmitter is inhibited when CTS is low.
12. Press
DTR/DSR
the following from the pop up menu:
OFF - Sets the DTR signal line permanently low.
ON - Sets the DTR signal line permanently high.
IBFull - Sets the DTR signal line high while the receiver buffer
can accept more data and sets DTR low when the data buffer is
full. The transmitter is inhibited when DSR is low.
The softkey is greyed out if the RS422 interface is selected.
DTR/DSR

Remote Interface Overview

You can view a summary of your remote interface settings at any time by
System
pressing ,
Remote Interface Interface Overview
Inputs
Examples of an HP-IB and RS422 interface overview are shown in
Figure 2-19.
2-56
and use any of the arrow hardkeys to select one of
and use any of the arrow hardkeys to select one of
, .
HP E4418B User's Guide