HP E4418B User Manual page 149

•
Recorder Output
Press this softkey to access a menu which allows you to modify the
setup of the recorder output. Refer to "Recorder Output", on
page 2-59 for further information.
Output Off On
Press this softkey to switch the rear panel Recorder Output on
or off. The Recorder Output produces a dc voltage that
corresponds to the selected input channel power level in
Watts.
Max Power
Press this softkey to enter the input power level that you want
to represent the 1 V
Recorder Output.
Min Power
Press this softkey to enter the input power level that you want
to represent the 0 V
Recorder Output.
•
Service
Press this softkey to access a menu which allows you to test and
service your power meter.
Self Test
Press this softkey to access the power meter's self test menu.
Instrument Self Test
Press this softkey to run a series of tests on the power meter.
Refer to "Instrument Self Test", on page 2-68 for further
information on the tests run.
Confidence Check
Press this softkey to verify that the power meter makes an
accurate measurement of it's 1 mW POWER REF output.
Individual
Press this softkey to access a menu which allows you to
select individual self tests to be run.
Memory
Press this softkey to perform a ROM checksum verification
test, verify the memory and that the correct amount of
RAM is present.
HP E4418B User's Guide
Front Panel Menu Reference "System/Inputs" Menu
maximum output voltage of the
dc
minimum output voltage of the
dc
Menu Reference
3-29