Removing/Installing The Batteries From/Into The Battery Pack; Removing; Installing - Invacare At’m Service Manual

SECTION 8—BATTERIES
Removing/Installing the Batteries From/Into the
Battery Pack
NOTE: For this procedure, refer to FIGURE 8.3.

Removing

1. Remove the battery pack from the wheelchair. Refer to Removing/Installing the
Battery Pack on page 39.
2. Open the battery pack by performing the following -
A. Grasp the side flaps and pull up.
B. Grasp the front flap and pull up.
3. Disconnect the wiring harness from the batteries in the following order -
A. NEGATIVE (-) BLACK battery cable from the NEGATIVE (-) battery terminal on
the left battery.
B. Circuit breaker from POSITIVE (+) battery terminal/post on the right battery.
C. WHITE battery cable (jumper) from the POSITIVE (+) battery terminal/post on the
left battery and the NEGATIVE (-) battery terminal/post on the right battery.
4. Remove the batteries from the battery pack.

Installing

1. Install the batteries into the battery pack in the orientation shown in FIGURE 8.3.
2. Connect the wiring harness to the batteries in the following order -
A. NEGATIVE (-) BLACK battery cable to the NEGATIVE (-) battery terminal on the
left battery.
B. Circuit breaker to POSITIVE (+) battery terminal/post on the right battery.
C. WHITE battery cable (jumper) to the POSITIVE (+) battery terminal/post on the left
battery and the NEGATIVE (-) battery terminal/post on the right battery.
3. Slide the RED and BLACK battery connector out of the battery pack in the slit
provided on the front flap.
4. Close the battery pack by performing the following -
A. Fold down the front flap and press to engage the hook and loop straps.
B. Fold down the side flaps and press to engage the hook and loop straps.
NOTE: Ensure that the hook and loop straps are securely fastened before lifting the battery pack.
5. Install the battery pack on the wheelchair. Refer to Removing/Installing the Battery
Pack on page 39.
At'm
40
Part No. 1125078