Removing/Installing The Battery Pack; Removing; Installing - Invacare At’m Service Manual

Removing/Installing the Battery Pack

NEVER unplug the battery cables by pulling on the wires. Unplug the battery cables
by pulling on the connector only. Otherwise, injury or damage may result.
NOTE: For this procedure, refer to FIGURE 8.2.

Removing

1. Verify the joystick on/off button is in the off position and disconnect the joystick. Refer
to Disconnecting/Connecting the Joystick on page 35.
2. Disconnect the battery connector from the wheelchair (RED and BLACK controller
connector).
3. Using the battery pack handle, lift the battery pack up and away from the wheelchair
base.

Installing

1. Verify the joystick on/off button is in the off position and disconnect the joystick. Refer
to Disconnecting/Connecting the Joystick on page 35.
2. Position the battery pack into the brackets located on the rear of the wheelchair.
3. Connect the battery connector to the connector on the rear of the wheelchair (RED and
BLACK connector).
4. Connect the joystick. Refer to Disconnecting/Connecting the Joystick on page 35.
Wheelchair Base
Part No. 1125078
WARNING
FIGURE 8.2 Removing/Installing the Battery Pack
RED and BLACK
Battery Connector
Brackets
RED and BLACK Controller Connector
39
SECTION 8—BATTERIES
Battery Pack
Handle
Battery Pack
At'm