Setting A Plug 'N Power Timer - Radio Shack 7-in-1 Remote Control with Lighted Keypad Owner's Manual

15-1924.fm Page 16 Monday, July 19, 1999 12:50 PM
9. To brighten or dim lights connected to lamp
and appliance modules, press the digit key
for the module you want to control. Then
hold down
VOLUME + (Brt)
on the 7-in-1. Release the key when
(Dim)
the desired level of brightness is reached.
Note: You must select the individual light to
brighten or dim even if you used
on the 7-in-1 to turn on all the lights
Lts On)
at the same time.

Setting a Plug 'n Power Timer

You can set the 7-in-1 Remote Control to turn on
or off a lamp/appliance module you select or turn
off all modules after a period of 1 to 99 minutes.
This works with an optional IR command console
or Plug 'n Power Wireless Remote Control Sys-
tem.
Note: When you use the 7-in-1 to control all mod-
ules at one time, the only command that works is
.
All Off
1. Press Plug 'n Power on the 7-in-1.
2. Hold down on the 7-in-1 until the red
TIMER
light above stays on.
Note: Skip Step 3 if you are turning all mod-
ules off using the
All Off
3. To turn on or off a specific module using the
7-in-1 Remote Control, press the digit keys
to enter the module's device code. The red
light blinks once.
4. Press (
On CHANNEL + (On)
to turn on), (
Off CHANNEL – (Off)
module to turn off), or
all modules to turn off.
When the red light blinks once, the 7-in-1
has accepted the code.
Need help? Call 1-800-989-4706
16
or
VOLUME –
POWER (All
command.
(to set a module
(to set a
(to set
MUTE (All Off)