IDD Processing & Packaging SQUIRE PLUS 2 Operation Manual page 59

M :
AINTENANCE
S
AFETY
Before starting any maintenance procedure, be sure to take the following precautions, in order:
1. Ensure you have protection:
• Wear protective eyewear
• Wear coveralls, gloves, and a helmet
• Ensure that there is running water available nearby
2. Ascertain the nature of the media as benign, polluting, corrosive, flammable, or in any other way
dangerous to handle
• Take proper precautions for dangerous media, as needed
• When using flammable media in the valve, position the correct fire extinguisher type near at hand
3. Make sure there is no pressure in the system, both before and after the valve position, and isolate the
valve for safety
4. Disassemble the valve and perform needed maintenance
P M
REVENTATIVE AINTENANCE
• Follow the above precautions
• Test the valve at least once a month to verify that it opens and closes correctly
• Regularly verify the state of all connections for both incoming and outgoing media
The maintenance of each valve depends on the conditions of its application. Valves should be cleaned and
serviced regularly. During each procedure, it is necessary to check the state of each component to make sure
that they are not worn out or damaged. Repairs are essential when one of the following occurs:
• Unusual noises
• Dripping
• Reduced flow rate
• Increased pressure drop
P R :
ARTS EPLACEMENT
The essential spare parts for all Assured Automation A
valves. used by IDD Process & Packaging, are supplied in a
S P K listed below.
PARE ARTS IT
1. Unscrew the actuator sleeve from the valve body
2. Take the plug pin out
3. Extract the plug from the stem and clean all accessible parts
4. Change the Kit
(plug, plug pin, sleeve gasket)
a. Place sleeve gasket into valve body
b. Re-attach the plug to the stem
c. Caulk and Replace the plug pin
5. Screw the actuator sleeve back into the valve body
6. Check that there is no internal or external leaking
7. Check that the valve is functioning correctly
8. Return the valve to service
A Kit Size
RES
KGJP1004 1/2"
This kit includes a sleeve gasket, plug, and plug pin.
Assured Automation will not be held responsible for any damage or injury to people,
things, or animals, due to improper use of the product, and declines any
responsibility on repairs performed by third parties.
Back To TOC
SQUIRE PLUS 2 OPERATIONS MANUAL
(if needed)
(under normal pressure)
Head Part No.
DN50 VA0167
PROCESS & PACKAGING, INC.
www.iddeas.com
(see Parts Replacement, below)
If any of these occur, the body of the valve
must be taken apart, the inside carefully
cleaned, and any damaged parts replaced.
angle
RES
P 59 125
AGE OF