Radio Shack 6 IN 1 RF REMOTE CONTROL SYSTEM Owner's Manual page 8

15-1919.fm Page 8 Monday, July 19, 1999 12:34 PM
3. Press down and hold
tor blinks twice, then release it and enter the 3-
digit manufacturer's code
.
3
SETUP
CD VCR
AUX 1 AUX 2
For example, to replace a Panasonic TV's remote
control (manufacturer's code 051), press:
TV SET UP 0 5 1
When the indicator blinks twice again, you have
correctly entered the code.
4. Point the system's remote control at your device
and press . The device should turn on (or off,
PWR
if it was on).
5. Repeat Steps 2–4 for additional devices.
If the remote does not operate your device, try other
codes listed in "Manufacturers' Codes" for your brand
of TV, VCR, cable converter, or other devices.
If your device still does not respond, follow the steps
outlined in "If You Have Problems."
Note: The punch-through feature is automatically
turned on for the TV's volume and mute controls. This
means that when you select cable (
of the volume buttons or the mute button, the remote
actually sends the codes to the television and not the
cable converter. If you want to use your cable convert-
er's volume and mute controls, disable the punch-
through feature for these buttons. See "Punch-
Through."
Need help? Call 1-800-950-7044!
8
until the red indica-
SET UP
All
PWR
Lts On
CBL TV
Plug'n
A/B
Power
) and press one
CBL