Summary of Contents for Radio Shack 6 IN 1 RF REMOTE CONTROL SYSTEM
Page 1
15-1919.fm Page 1 Monday, July 19, 1999 12:34 PM Cat. No. 15-1919 OWNER’S MANUAL Please read before using this equipment. 6 IN 1 RF REMOTE CONTROL SYSTEM...
Page 2
The 6 in 1 RF Remote Control’s features include: IR (Infrared) and RF (Radio-Frequency) Commands — let you use the 6 in 1 RF Remote Control system’s remote control with the system’s RF command console to control your IR remote-controlled devices from up to 100 feet away, even through walls.
Page 3
System by calling 1-800-950-7044. You can even have the manufacturer’s codes for your remote-con- trolled devices programmed into your remote control by phone! Note: You need four AAA batteries (not supplied) to power your 6 in 1 RF Remote Control System. Need help? Call 1-800-950-7044!
15-1919.fm Page 4 Monday, July 19, 1999 12:34 PM CONTENTS How the System Works ... 5 A Look at the System’s Remote Control ... 5 Setting Up the System ... 7 Installing Batteries in the Remote Control ... 7 Setting Up the Remote Control ... 7 Setting Up the System’s RF Command Console ...
15-1919.fm Page 5 Monday, July 19, 1999 12:34 PM HOW THE SYSTEM WORKS When you press a key on the system’s remote control, it sends a powerful RF signal to the RF command con- sole, which then sends a corresponding IR signal to IR remote controlled-devices in the same room as the command console.
Page 6
15-1919.fm Page 6 Monday, July 19, 1999 12:34 PM The system’s remote control also has these special keys. Function SET UP Sets up the system’s remote control to replace your original remote con- trols. CD, VCR, During set up, tells the system’s re- CBL, TV, mote control which remote controls AUX1, AUX 2,...
Your system’s remote control uses four AAA batteries (not supplied) for power. We recommend alkaline bat- teries, such as Radio Shack Cat. No. 23-555. Follow these steps to install the batteries. 1. Press the battery compartment cover tab and lift off the cover.
Page 8
15-1919.fm Page 8 Monday, July 19, 1999 12:34 PM 3. Press down and hold until the red indica- SET UP tor blinks twice, then release it and enter the 3- digit manufacturer’s code SETUP Lts On AUX 1 AUX 2 For example, to replace a Panasonic TV’s remote control (manufacturer’s code 051), press: TV SET UP 0 5 1...
15-1919.fm Page 9 Monday, July 19, 1999 12:34 PM SETTING UP THE SYSTEM’S RF COMMAND CONSOLE After you set up the system’s remote control, just plug the RF command console’s power cord into any stan- dard AC outlet in the same room as your IR remote controlled devices (TV, VCR, cable box, and so on) and fully extend its antenna.
15-1919.fm Page 10 Monday, July 19, 1999 12:34 PM OPERATION Each of the system’s remote control device keys are preset to control particular devices, as shown in this list. — TVs only — Cable converters, satellite receivers, and video accessories —...
15-1919.fm Page 11 Monday, July 19, 1999 12:34 PM Note: The command keys on the system’s remote control work the same as the keys on the device’s original remote control; however, the labeling might differ slightly. USING TWO OR MORE SIMILAR DEVICES Normally, you us each device key to control one of its listed devices (see “Operation”).
(if available) of your TV, VCR, cable box, or other devices that you want to pro- gram into your system’s remote control. Have this information ready when you call the Radio Shack Customer Service Representative. Note: If you are unsure of your remote controlled device’s specific model number or manufacture...
15-1919.fm Page 13 Monday, July 19, 1999 12:34 PM 4. Hold the system’s remote control up to your tele- phone’s earpiece. Note: You must hold the telephone’s earpiece over the remote control’s battery compartment. If you do not, the system’s remote control might not be able to properly receive the in- formation coming over the phone.
15-1919.fm Page 14 Monday, July 19, 1999 12:34 PM 7. To exit the fast search mode, press Note: You can search up to 11 codes for a particular device (TV, VCR, cable, and so on). Channel Scan The channel scan feature lets you scan through all channels on your TV, VCR, or cable box, stopping at each channel for about 3 seconds.
15-1919.fm Page 15 Monday, July 19, 1999 12:34 PM Notes: • You must enter a zero before a single-digit channel number (01, 02, 03, and so on). • If you normally press ENTER channel number to change to a new channel, you must press instead of ENTER...
Here’s how it works. The 6 in 1 RF Remote Control System’s remote control keys are not all used by every device. For example, a TV is often the only device that uses...
Page 17
15-1919.fm Page 17 Monday, July 19, 1999 12:34 PM The punch-through feature does not work if the last two devices you select have the same (or similar) features. For example, most TVs and some cable converters have CHANNEL keys on their remote controls. In this case, you must press the desired device key before you use the remote control’s keys.
The Plug ’n Power feature lets you use the system to control lamps and appliances with Plug ’n Power mod- ules, available at your local Radio Shack store. Follow these steps to control Plug ’n Power modules with the system’s remote control and RF command console.
Page 19
15-1919.fm Page 19 Monday, July 19, 1999 12:34 PM 4. To turn on all light and appliance modules with your remote control, press All Lts On remote control, or ALL LIGHTS ON mand console. SETUP Lts On Note: This affects all light modules and wall switch modules set to the same house code as the command console.
Page 20
15-1919.fm Page 20 Monday, July 19, 1999 12:34 PM To control specific lamps and appliances directly from the RF command console, press the top but- ton of the corresponding module number ( ) to turn on the module. Press the bot- tom button to turn off the module.
15-1919.fm Page 21 Monday, July 19, 1999 12:34 PM MANUFACTURERS’ CODES The following list tells you which 3-digit codes to enter to set up the 6 in 1 RF Remote Control System’s re- mote control. Notes: • Use the supplied label to record the manufactur- ers’...
15-1919.fm Page 48 Monday, July 19, 1999 12:34 PM SETUP CODES FOR AUDIO CASSETTE DECKS (continued) Proton Sansui Sony 170, 243 Wards Yamaha SETUP CODES FOR HOME AUTOMATION One-For-All Radio Shack Security System Universal One-For-All Security System Need help? Call 1-800-950-7044!
15-1919.fm Page 49 Monday, July 19, 1999 12:34 PM IF YOU HAVE PROBLEMS SEARCHING THE CODE LIBRARY If the 6 in 1 RF Remote Control System’s remote con- trol does not operate your remote-controlled devices when you first set it up, you probably haven’t entered the correct 3-digit codes for your devices.
• If some buttons do not function for your device, you might be able to search for a better device code. If you are still unable to determine the problem, call our nationwide Universal Remote Control Hotline at 1-800- 950-7044. Need help? Call 1-800-950-7044!
• Move the RF command console away from the radio/TV. • Plug the RF command console into an outlet on a different electrical circuit from the radio/TV experi- encing the interference. Contact your local Radio Shack store if the problem continues. Need help? Call 1-800-950-7044!
Modifying or tampering with the system’s internal com- ponents can cause a malfunction and invalidate your system’s warranty. If your system is not performing as it should, take it to your local Radio Shack store for as- sistance. Need help? Call 1-800-950-7044!
15-1919.fm Page 53 Monday, July 19, 1999 12:34 PM SPECIFICATIONS Remote Power... 4 AAA Alkaline Batteries RF Command Console Power... 120 Volts AC Remote to RF Command Console Range...100 Feet (304.8 m) RF Command Console to Device Range...25 Feet (7.62 m) 30 Remote Dimensions .2 RF Command Console Dimensions...
Page 54
15-1919.fm Page 54 Monday, July 19, 1999 12:34 PM NOTES Need help? Call 1-800-950-7044!
Page 55
15-1919.fm Page 55 Monday, July 19, 1999 12:34 PM Need help? Call 1-800-950-7044!
Page 56
Radio Shack company owned stores and authorized Radio Shack franchisees and dealers. Within this period Radio Shack will repair the security product without charge for parts and labor. Simply bring your Radio Shack sales slip as proof-of-purchase date to any Radio Shack store.
Need help?
Do you have a question about the 6 IN 1 RF REMOTE CONTROL SYSTEM and is the answer not in the manual?
Questions and answers