Setting Up The System; Installing Batteries In The Remote Control; Setting Up The Remote Control - Radio Shack 6 IN 1 RF REMOTE CONTROL SYSTEM Owner's Manual

Radio shack 6 in 1 rf remote control system owner's manual
Table of Contents

Advertisement

15-1919.fm Page 7 Monday, July 19, 1999 12:34 PM

SETTING UP THE SYSTEM

INSTALLING BATTERIES IN THE
REMOTE CONTROL
Your system's remote control uses four AAA batteries
(not supplied) for power. We recommend alkaline bat-
teries, such as Radio Shack Cat. No. 23-555. Follow
these steps to install the batteries.
1. Press the battery compartment cover tab and lift
off the cover.
2. Install four fresh batteries, as indicated by the
polarity symbols marked in the compartment.
3. Replace the cover.
Notes:
• Do not place objects on top of the remote control
after you install the batteries. This can press down
keys and reduce battery life.
• When the remote control's range decreases or it
operates erratically, replace the batteries.
• Be sure to have fresh batteries ready to install
before you remove the old batteries. The remote
control's memory only lasts about a minute with-
out the batteries. If the memory is lost, you must
re-enter the 3-digit manufacturer's codes for your
remote-controlled devices.
SETTING UP THE REMOTE
CONTROL
1. Refer to "Manufacturers' Codes" and write down
the codes for your remote-controlled devices on
the provided label.
2. Press the device key for the remote control you
are replacing (
,
CD
VCR
SETUP
CD
VCR
AUX 1
AUX 2
1
2
Need help? Call 1-800-950-7044!
,
,
,
, or
).
CBL
TV
AUX1
AUX 2
All
PWR
Lts On
CBL
TV
Plug'n
A/B
Power
On
3
CH
7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 6 IN 1 RF REMOTE CONTROL SYSTEM and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

15-1919

Table of Contents