Frequently Asked Questions - Marantz RC5400 User Manual

Frequently Asked Questions

Can I program a device button to execute more than one com-
mand?
Yes, you can. You can program a macro to the device button in the
MACRO mode. (see page 42).
How do I program source switching?
See "Programming The Device Buttons ..." on page 28.
How can I edit buttons which are programmed macro on home
pages?
You can do this using "Macro to DEVICE" function via the MACRO
mode. All changes you make to these items are automatically upda-
ted in the Home page (page 43).
How can I label buttons on home pages?
You can do this using "Label Device" function via the LABEL mode.
All changes you make to these items are automatically updated in
the Home page (page 32).
How can I delete buttons on home pages?
You can do this using "Delete Device" function via the DELETE
mode. All changes you make to these items are automatically upda-
ted in the Home page (page 38).
How do I reset the RC5400?
Normally, you never have to reset the RC5400. However, if the
RC5400's display freezes or if you notice unusual behavior, you
might need to reset the RC5400. You will not lose any saved pro-
grammed commands or macros.
Carefully press the reset button inside the battery compartment of
the RC5400 with a paperclip or sharp pencil. The RC5400 restarts
and beeps to indicate it is ready for use.
Can I revert to the original configuration?
Yes, by using the "Revert" function on the third Setup page or
Wizz.it with Windows PC. By using Wizz.it, once the program is
installed, open a configuration file named RC5400_Default in
C/:Program Files/Wizzit/Samples. Downloading this configuration to
your RC5400 will restore your RC5400 to its factory state.
User Guide
52