Recharging Problems - Marantz RC5400 User Manual

The TV goes blank or the input source changes
The Device Overview page item might be programmed to switch
n
the input source. Select the device without issuing IR codes
(page 8).
The configuration file is corrupted
When this very unlikely event occurs, you have to use the
n
"Revert" button on the third Setup page (page 13). All your
customized commands, devices, and macros will be lost, and
you will have to reprogram your RC5400. Should you need the
Marantz factory default configuration, you will have to use the
Wizz.it with a Windows PC to restore it (page 46).
Error messages
If one of the following error messages occurs, please contact
n
your Marantz authorized dealer or Marantz customer service:
l
l
l
l
Tip

Recharging Problems

The batteries won't recharge
Make sure you are using the rechargeable battery pack and the
n
docking station supplied with your RC5400.
Make sure the battery pack is installed properly in your Remote
n
Control (see page 4).
The indicator light on the docking station flashes
Check if the contacts on the docking station are clean and free
n
of obstructions.
Make sure the RC5400 lies properly on the docking station.
n
Make sure the battery pack is installed properly (see page 5).
n
User Guide
Can't open configuration file
Configuration file error
No configuration file found
Invalid configuration file version
The bulletin boards and friendly users at www.remotecentral.com
can often give you help with problems on weekends or in eve-
nings when your Marantz authorized dealer or Marantz technical
support may not be available.
51
Troubleshooting