ChimneyFree 18EF010GAA User Manual page 7

4
Wooden
Ember Nut
Logs/Ember bed
Ember bed Mounting Post
5
Ember bed Light Bulb
Light Bulb Holding Spring
CLEARANCE TO COMBUSTIBLES
Keep electrical cords, drapery, furniture and other combustibles at least 3 ft. from the front of the heater and away
from the sides.
CLEANING TRIM
Clean the metal trim using a soft cloth, slightly dampened with a citrus oil-based product and buff with a clean soft
cloth. Do not use brass polish or household cleaners as these products will damage the metal trim. Citrus oil-based
products can be obtained at supermarkets or hardware stores.
• The motors used on the fan and the flame generator assembly are pre-lubricated for extended bearing life and
require no further lubrication. However, we recommend periodic cleaning/vacuuming of the fan/heater.
• Make sure the unit is turned off and unplugged whenever you are cleaning the heater or fireplace.
A119
4. Turn nuts counterclockwise to loosen, remove and set
aside. Securely grab logs on left and right side and lift
log/ember bed assembly straight up. Once ember bed
has cleared the support bracket and threaded rods,
bring log/ember bed assembly forward and out of unit
and set aside in a safe place (Fig. 4).
5. Unhook light bulb spring clips from the bulbs, and
unscrew the bulbs (Fig. 5) After replacing the
bulbs make sure to replace the light bulb spring
clip.
Follow steps 1 through 4 in reverse order to
reinstall front frame assembly into your insert.
Pull
Pull
7
www.tsicustomerservice.com