Table of Contents
Advertisement
Document ID: 2098062
2. Place the bleed hose of the fuel pressure gage into an approved gasoline container.
3. Open the bleed valve on the fuel pressure gage in order to bleed the air from the gage.
4. Turn ON the ignition, with the engine OFF.
5. Command the fuel pump ON with a scan tool until all of the air is bled out of the gage.
6. Close the bleed valve on the fuel pressure gage.
7. Command the fuel pump ON with a scan tool.
8. Inspect for fuel leaks.
Removal Procedure
1. Place the fuel pressure gage bleed hose into an approved container and open the bleed valve
to bleed fuel system pressure.
2. Place a shop towel under the fuel pressure gage to catch any remaining fuel spillage.
3. Remove the
J 34730-1A
4. Drain any fuel remaining in the fuel pressure gage into an approved container.
5. Install the cap on the fuel pressure connection.
6. Place the shop towel in an approved container.
http://localhost:9001/si/showDoc.do?docSyskey=2098062&pubCellSyskey=124955&pubO...
from fuel pressure connection.
Page 2 of 2
7/5/2010
Hide quick links:
Advertisement
Table of Contents
