Document ID: 2098058
Note: If the electronic throttle control valve is removed from the throttle body, the throttle
body may be cleaned in a cold immersion type cleaner. Do not clean the electronic throttle
control valve with any type of solvent or cleaner.
2. Clean the throttle body.
3. Install the electronic throttle body assembly with a new gasket.
Caution:
Refer to
4. Install the electronic throttle body retaining nuts and bolts.
Tighten
Tighten the throttle body retaining bolts and nuts to 15 N·m (11 lb ft).
5. Connect the electronic throttle body electrical connector.
6. Install the throttle body coolant hoses.
http://localhost:9001/si/showDoc.do?docSyskey=2098058&pubCellSyskey=124952&pubO...
in the Preface section.
Fastener Caution
Page 3 of 4
7/5/2010